Our Lab Homogenizer's - Features and Benefits

 Continuously adjustable process pressure from 1,500 psi (10 MPa) to 60,000 psi (410 MPa) allows processing of ingredients that are difficult or uneconomical to process in any other way, offering the widest scope of formulations

 The homogenising valve features ceramic needle and seat with profiled geometry for optimised performance. Pneumatically controlled, it provides constant pressure and allows fine adjustment

 Choice of (easily interchangeable) processing cells: 1 ml, 10 ml, 18 ml and 35 ml

 The inverted design and full-stroking piston with bore seal practically eliminates dead volume

 Can be run in single-shot mode - including very viscous formulations - and continuous mode (except the 1 ml cell). The flow rate in both modes is adjustable from drop-by drop to 200 ml/min (depending on the processing cell and formulation)

 All wetted parts are simply removable without tools in less than one minute for cleaning, sterilization (including autoclave), pre-cooling, or pre-warming, all as required by the sample/process

 Three options for temperature control

 

 

 

 

 

 

 

 

Write a review

Your Name:


Your Review:
Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: